Chat with us, powered by LiveChat

How to reset controllers on RetroPie

|||||||||||||||||||||
|||||||||||||||||||||
Last updated: 21 November 2021
Estimated reading time: 1 min

If you find yourself in the situation where you are not able to use a controller on the menus then you can follow the steps below to reset it if you have a USB keyboard.

The following steps which will reset the controller input and when it next boots it will have the option to configure the controllers.

Plug a USB keyboard into one of the side USB ports.
Plug the controller(s) into the front USB ports.

When it has booted up to the menu, Press F4 on keyboard, this will go to command prompt
Type in: sudo ~/RetroPie-Setup/retropie_setup.sh and press Return on the keyboard

Choose Manage Packages

Choose Manage Core Packages

Choose emulationstation (Installed)

Choose Configurations / Options (it may also be named Configurations Tools)

Choose the option to Clear/Reset Emulation Station input configuration

Choose Yes to proceed to clear the controller settings.

A prompt will confirm the settings have been cleared. Choose OK and then keep choosing Exit to return to the Command Prompt screen.

Type: reboot and press Return on the keyboard.

This will reboot the system and go back into the menus where you will be able to reconfigure the controls when prompted.

Do this for the first controller and to skip buttons, hold any button for a couple of seconds. Then when you get to HOTKEY, press the SELECT button.

Then for the second controller, press START and you will see an option for configuring a controller. You can repeat the process again.

Your controllers are now set up.

Tags:
Was this article helpful?
Dislike 9